Thread: Frame Welding
View Single Post
Old 10-29-2012, 10:59 AM   #173
Kenn
Senior Member
 
Kenn's Avatar
 
Join Date: Sep 2010
Location: Willamina Or
Posts: 277
Default cab interior

I have been unable to post any pictures because my computer lost it's hard drive. I got a rebuilt computer and all of the software is a bit different. I think I am getting better with it. I have spent the last week working in the cab. I had to fine tune the fit of the headliner and move the speaker holes (I need a hole slider). I have installed a Pioneer AM/FM chepo radio, a Cobra 29 LXBT CB and a back-up camera and lots of wires. Both of the radio antennas will run through the boot of the walk through so I have a lot of speaker wire and antenna leads hanging from the back of the cab. Next up is to install the seats, panels and then put the hood back on.
Attached Thumbnails
IM000172.jpg   IM000153a.jpg   IM000179.jpg   IM000177.jpg  
Kenn is offline   Reply With Quote