Forum: Truck Conversion General Discussions
01-15-2024, 02:29 PM
|
Replies: 0
Views: 330
2005 FL 120 Dash died
My dash is dead. Starts normally, runs just fine, etc. but no cycling of the dash instruments with the key on, and all are pegged at "0" after start-up. My ScanGaugeD gives me the temps, voltage,...
|
Forum: Manufacturer Discussion
07-11-2021, 04:32 PM
|
Replies: 6
Views: 3,043
Switch
As mentioned previously, look for a toggle switch. Start flipping all the switches and see what moves. I had the same problem with an "Elite" brand RV. Turns out it was not built by Elite and have no...
|
Forum: Truck Conversion General Discussions
10-21-2018, 04:14 PM
|
Replies: 6
Views: 2,970
|
Forum: Manufacturer Discussion
04-07-2018, 11:45 AM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
04-07-2018, 11:31 AM
|
Replies: 112
Views: 50,266
I rode with two truckers and they showed me how...
I rode with two truckers and they showed me how to float the gears but they both were old timers and long ago forgot the mechanics and shifted by sound and feel. After studying the rpm/speed shift...
|
Forum: Manufacturer Discussion
04-07-2018, 08:41 AM
|
Replies: 112
Views: 50,266
Auto to manual conversion
~9K undertaking because it was a two pedal. Much easier to convert had it been a three pedal auto. I gave up on it because over the last two years every sensor, harness, TCU, XY shifter, etc had been...
|
Forum: Manufacturer Discussion
04-06-2018, 01:08 PM
|
Replies: 112
Views: 50,266
Elec fix/trans fix Update
A long nightmare of a story relative to the POS Eaton auto shift problems in the last 3 months so I ripped it out and converted it back to a three pedal manual. Eaton nightmare over! But, shifting a...
|
Forum: Manufacturer Discussion
11-25-2017, 04:47 PM
|
Replies: 112
Views: 50,266
I still have a couple of switches with unknown...
I still have a couple of switches with unknown functions and 120v plus 12v Bass multi-switch breaker panel to figure out. In "is this broken or do I just not know how to operate it mode" with a lot...
|
Forum: Manufacturer Discussion
11-25-2017, 01:21 PM
|
Replies: 112
Views: 50,266
Charger
Just a few days ago installed the Progressive Dynamics 9270 charger and works just as BushPilot said it would. It cycles through three charge rates and automatically goes into storage mode. Like a...
|
Forum: Manufacturer Discussion
11-17-2017, 09:17 AM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-16-2017, 04:07 PM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-16-2017, 01:52 PM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-16-2017, 11:26 AM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-16-2017, 06:45 AM
|
Replies: 112
Views: 50,266
Batteries crossed
After much head scratching and your comments, it looks like I have this figured out. The wiring was definitely crossed up at some point in time. The charger, which I will dump on your advice, is...
|
Forum: Manufacturer Discussion
11-15-2017, 04:59 PM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-15-2017, 03:54 PM
|
Replies: 112
Views: 50,266
Batteries
2683
2684
2685
2686
Photos might help but here is what I have. Batteries disconnected with "store/use" switch which must be the battery disconnect solenoid control. 12.7 v at 4 bank of...
|
Forum: Manufacturer Discussion
11-15-2017, 09:26 AM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
11-14-2017, 12:43 PM
|
Replies: 112
Views: 50,266
Elite trans problem update
2nd FL dealership(and I) gave up on figuring out the autoshift problem after Eaton had no ideas about it other than installing a new XYshifter and TCU and they were not certain if that would fix it...
|
Forum: Manufacturer Discussion
09-02-2017, 11:57 AM
|
Replies: 112
Views: 50,266
Trouble within 1 hour
Picked up the 2005 Elite RV with Detroit 60 series and Eaton 10 speed and right away had trouble with the trans shifting out and back into 10th gear. Traded a conventional RV for this Freightliner RV...
|
Forum: Manufacturer Discussion
08-10-2017, 05:01 PM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
08-10-2017, 03:16 PM
|
Replies: 112
Views: 50,266
|
Forum: Manufacturer Discussion
08-09-2017, 12:39 PM
|
Replies: 112
Views: 50,266
MC purchase update
Been a long time looking at Racing Junk every day while waiting on repair of MH which turned out to be a long drawn out mess with the Ins Co and Lazy Days body shop going back and forth. Will say...
|
Forum: Manufacturer Discussion
12-19-2016, 07:26 PM
|
Replies: 112
Views: 50,266
Engine choice
Cannot thank you enough for your reply. Diesel mechanics know what is what like I knew(now retired) what was what as a practicing Orthodontist and listened to other Orthodontists when I was treating...
|
Forum: Manufacturer Discussion
12-19-2016, 04:58 PM
|
Replies: 112
Views: 50,266
Freightliner
You sorta lost me with the Freightliner and everyone being able to work on them which suggests that Freightliner has a standard fitted engine which is? I suppose you are right that the important...
|
Forum: Manufacturer Discussion
12-19-2016, 03:10 PM
|
Replies: 112
Views: 50,266
~32ft tag Motorcoach
Need to wake up, Deepvee, Bushpilot, Bob86224, petrel and other smart MC owners again on my hunt for a MC. Got hung up and delayed due to an unexpected Cummins repair. Fuel pump failed and found a...
|