Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×


Join Truck Conversion Today
Showing results 1 to 25 of 109
Search took 0.01 seconds.
Search: Posts Made By: Bob E
Forum: Truck Conversion General Discussions 05-16-2012, 05:42 PM
Replies: 4
Views: 15,332
Posted By Bob E
I just finished pouring the floor for my...

I just finished pouring the floor for my Conversion parking canope. We excavated 12" of dirt & clay, layed a crushed rock base (a couple of inches) then put in 4" of sand. We then layed in 1/2"...
Forum: Truck Conversion General Discussions 03-17-2012, 06:27 PM
Replies: 5
Views: 2,729
Posted By Bob E
As to your generator question, . . . I assume...

As to your generator question, . . . I assume it's a diesel, in which case 5000 hours may or may not be a negative. As opposed to a vehicle engine, . . .the gen set runs at a constant speed (1800...
Forum: Building Your Own 03-02-2012, 06:30 PM
Replies: 3
Views: 3,622
Posted By Bob E
Your idea sounds good. Also, Honda & Yamaha both...

Your idea sounds good. Also, Honda & Yamaha both make inverter-generators that have a load sensing module. They run a little above idle under light loading and increase RPM as the load becomes...
Forum: Building Your Own 01-26-2012, 06:36 PM
Replies: 16
Views: 7,887
Posted By Bob E
Harley, I just happen to have a new (never...

Harley, I just happen to have a new (never installed) Coleman basement air/heat pump, complete with integrated thermostat & wiring harness. I think it's a 30,000 btu unit but I would need to look at...
Forum: Truck Conversion General Discussions 11-03-2011, 04:48 PM
Replies: 3
Views: 7,529
Posted By Bob E
You might also check Welcome To The Yard...

You might also check Welcome To The Yard (https://www.yardstore.com/) in Wichita, Ks, . . .they carry a large inventory of new & used riviting tools, . . .if you don't see what you want on their...
Forum: Building Your Own 08-21-2011, 03:22 PM
Replies: 16
Views: 7,080
Posted By Bob E
You might try St Farm, . . . they insd mine with...

You might try St Farm, . . . they insd mine with no problems, . . .however, . .I did have all my other cars, pickup trucks, & house with them, . . .this may have helped.
Forum: Building Your Own 07-25-2011, 04:12 PM
Replies: 6
Views: 7,966
Posted By Bob E
I would agree, . .zinc chromate is fantastic, . ....

I would agree, . .zinc chromate is fantastic, . . .however, . . .last I knew the EPA killed it, . .or made the manufacturers change the formula, . . probably not as good as the old stuff. Damn gov't...
Forum: Truck Conversion General Discussions 07-14-2011, 07:36 PM
Replies: 13
Views: 12,526
Posted By Bob E
Several diesel truck sites have discussions on...

Several diesel truck sites have discussions on propane injection, . . .I know of a couple of farmers that are using this on their tractors. They all note better performance & better (combined) fuel...
Forum: Building Your Own 03-19-2011, 04:56 PM
Replies: 3
Views: 9,169
Posted By Bob E
If you want a fail safe seal btwn the boot & the...

If you want a fail safe seal btwn the boot & the cab/motorhome body, use some urthane windshield adhesive to glue the boot in. . . . just don't ever plan on taking it loose later on.
Forum: Building Your Own 03-19-2011, 04:50 PM
Replies: 4
Views: 2,697
Posted By Bob E
Done that myself, . . . found some plastic tooth...

Done that myself, . . . found some plastic tooth pick's that matched the shape of the original needle perfectly.
Forum: Building Your Own 02-27-2011, 03:09 PM
Replies: 10
Views: 5,939
Posted By Bob E
When I did my first bus conversion (30 years ago)...

When I did my first bus conversion (30 years ago) I made a deal with an RV repair facility to "borrow" one of their stalls in the winter months, in exchange for labor during their busy season. (I'm...
Forum: Building Your Own 02-07-2011, 11:02 PM
Replies: 8
Views: 4,826
Posted By Bob E
The outer skins on my truck are .050 alum &...

The outer skins on my truck are .050 alum & originally installed with 3M VHB bonding tape with no screws or rivits.. Before I started on the interior, I had a couple seams come loose. I bought a...
Forum: Truck Conversion General Discussions 02-04-2011, 06:31 PM
Replies: 2
Views: 3,386
Posted By Bob E
I've also got St Farm, . . .my agent didn't have...

I've also got St Farm, . . .my agent didn't have any problem with the underwriting dept, . . .but also have 4 cars, 2 pick-ups, a motorcycle & 2 houses with them so they probably didn't want me to go...
Forum: Building Your Own 12-20-2010, 10:29 AM
Replies: 5
Views: 3,652
Posted By Bob E
The generator starter shouldn't pull over...

The generator starter shouldn't pull over 100Amps. Charge amprage from the 12V generator alternator will likely be in the 20 to 25 Amp range (max).
You can get an induction amp meter Alter Systems...
Forum: Building Your Own 12-19-2010, 11:08 PM
Replies: 5
Views: 5,420
Posted By Bob E
From the way you're describing your load...

From the way you're describing your load situation, you might want to consider two 1500or 2000 watt inverters, . . .one on each 120V leg. Then you would have enough AC power to run everything (and...
Forum: Building Your Own 12-19-2010, 10:23 PM
Replies: 5
Views: 3,652
Posted By Bob E
Yup, . . .fuse (or install a breaker) on...

Yup, . . .fuse (or install a breaker) on everything (where practical) as you never know where those little electrical gremlins are going to appear - or when. All it takes is a mis-placed staple or...
Forum: Truck Conversion General Discussions 07-23-2010, 07:17 AM
Replies: 18
Views: 5,494
Posted By Bob E
Suggest you install a separate box between the...

Suggest you install a separate box between the main breaker box and your rear A/C unit. then equip that box with a "transfer switch" rated at 20amps. A transfer switch is basically a double pole,...
Forum: Building Your Own 05-26-2010, 05:55 PM
Replies: 299
Views: 161,621
Posted By Bob E
Actually, I built one from an 8 X 22' enclosed...

Actually, I built one from an 8 X 22' enclosed with ramp door.
I insulated the walls & roof, wired it for 110V AC with 30 amp RV service, 12V lights, installed an 18" awning, checkerboard tile...
Forum: Building Your Own 05-12-2010, 09:06 PM
Replies: 299
Views: 161,621
Posted By Bob E
Just a suggestion,...why don't you leave the 12V...

Just a suggestion,...why don't you leave the 12V cig lighter recepticles & just add the Anderson Power Pole plugs to the same box.

Then you will be able to power up just about any 12V accessory...
Forum: Truck Conversion General Discussions 05-08-2010, 07:25 PM
Replies: 3
Views: 2,405
Posted By Bob E
Also, be aware that most LED's don't project...

Also, be aware that most LED's don't project light very far even though they appear very bright when you look at them.
However, if what you have is a true LED backup light, it should do what you...
Forum: Building Your Own 04-17-2010, 09:03 PM
Replies: 5
Views: 2,646
Posted By Bob E
Ham radio guys are knowledgable when it comes to...

Ham radio guys are knowledgable when it comes to static generated by 120VAC & how to eliminate even the most minor AC interference.

Suggest goggle ham radio for more info or try Ebay for a 120VAC...
Forum: Truck Conversion General Discussions 03-23-2010, 09:15 PM
Replies: 9
Views: 2,447
Posted By Bob E
Geo, Say hi to Barry at the OOIDA booth(Owners,...

Geo,
Say hi to Barry at the OOIDA booth(Owners, Operators, & Independent Drivers Assn.)while you're at the Mid-Am Show.
He's the only one (besides me) that has ever driven my conversion.

Bob E.
Forum: Building Your Own 03-06-2010, 07:29 PM
Replies: 97
Views: 47,242
Posted By Bob E
Ya,...but there isn't any inflation (just listen...

Ya,...but there isn't any inflation (just listen to the national news, they'll tell you the "straight truth"!!!) uh-huh
Forum: Truck Conversion General Discussions 02-08-2010, 02:44 PM
Replies: 1
Views: 1,988
Posted By Bob E
Several stainless polish compounds are available,...

Several stainless polish compounds are available, along with automotive paint cleaner products (which will also work on stainless.
(Try an auto body paint supply store for buffer & polish materials)...
Forum: Building Your Own 02-08-2010, 02:36 PM
Replies: 8
Views: 3,248
Posted By Bob E
Suggest go to an upholstery supply store & look...

Suggest go to an upholstery supply store & look at their selection of loaded foam. Most handle it in various thickness & dimensions.
Showing results 1 to 25 of 109

 
Forum Jump

All times are GMT -5. The time now is 02:03 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
×