View Single Post
Old 07-05-2017, 08:35 PM   #21
Egon
Member
 
Join Date: Jun 2017
Location: Albuquerque
Posts: 30
Default

End of Week 2 Update:

Removed a lot of wallpaper, very difficult because its heat bonded, but in my opinion its an essential step of a good restore job. Simply painting over the wallpaper can be a waste of time because it will eventually curl up, and removing all the wallpaper allows me to see any hidden water damage. Wallpaper usually won't peel up until the plywood underneath is rotted, and then its too late and the plywood underneath needs to be removed.

To remove heat bonded wallpaper, simply get a razor blade and make long cuts floor to ceiling. This will divide it into 8 inch wide vertical strips. Then peel at a corder until the top half is loose. Pull the strip down in one piece slowly. Some say heat guns help but I've had limited success.

Thanks to removing the wallpaper, more small sections of water damaged plywood were discovered and will be removed/repaired prior to painting
Egon is offline   Reply With Quote