View Single Post
Old 03-14-2016, 11:37 AM   #52
Bob86ZZ4
Senior Member
 
Bob86ZZ4's Avatar
 
Join Date: Feb 2009
Location: St. Paul, MN
Posts: 1,819
Default

Got it all in. I made a couple of square steel tubing mounts for the bottom front. I wanted to mount the fridge out far enough to allow a bit of air to circulate. In order to do that I needed to have it stick out to a point that the front levelers were in free air. So, I removed those and used the steel tubing to bolt through. It works great. I can adjust the height to have the fridge level in the opening. Cosmetically I suppose it's not the greatest. But, I'm all about function over beauty.



Then up top I used a couple of small L brackets and attached them where the door hinge bolts are. I used a nut to space between the L brackets and the wood above the fridge. Quick and easy. Again, probably not the prettiest and I'm sure others could do a much better job somehow. But, I'm not much good at pretty.

__________________
'03 Freightliner FL112, 295" wheel base, with '03 United Specialties 26' living quarters, single screw, Cat C12 430 h/p 1650 torque, Eaton 10speed , 3.42 rear axle ratio
Bob86ZZ4 is offline   Reply With Quote