Thread: Frame Welding
View Single Post
Old 06-17-2015, 11:08 PM   #391
Kenn
Senior Member
 
Kenn's Avatar
 
Join Date: Sep 2010
Location: Willamina Or
Posts: 277
Default finished bath

My brother and I finished the bath today. The worst part is trying to get good pictures inside a small space. I had the three drawer boxes build from birch plywood with dovetails. The cost was $111.00 and it took about ten days. They do good work and save me a lot of time. I made the faces for the drawers with 3/4 x 1 1/2 oak and plywood in the centers. They are held to the drawer boxes with the handle screws. We used self closing full extension drawer glides. Each drawer is 22" wide, 18" deep and 8 1/2" tall. The two large doors are for the hanging closet and the door at the rear is to the generator and water heater exhaust compartment. I will also store my broom in that space. I built the under-sink doors so they look like a base unit, but when both doors are open I have clear access to the plumbing and water heater. We used Formica for the countertop and the walls. It feels good to have one part of the interior done.
Attached Thumbnails
IM000761.jpg   IM000766.jpg   IM000762.jpg   IM000764.jpg  
Kenn is offline   Reply With Quote