[Kenn]

Been busy putting in the new waterheater. I went with a tankless from Precision Temp in Ohio. It seems to be well made. The intake air and the exhaust vent both go through the floor and nothing goes through the sidewall. One picture is from under the truck looking up. The square hole is intake and the round is exhaust and will have a tailpipe added. The picture of the floor shoes the holes from above. I got the LPG line in and the wires done I will do the water lines tomorrow. I also got the furnace in and the water lines and kitchen sink drain line in. The picture of the wall has a wire chase (white) the kitchen sink drain (center) and the holding vent that goes through the roof. The large hole is for a heater duct that will be into the bathroom. The weather has warmed up a bit so I have been painting the plywood walls and ceiling. I also got the upper refrigerator vent installed. I hope to be done with the bath except the cabinets in the next week.