View Single Post
Old 03-10-2011, 08:27 PM   #5
Bob86ZZ4
Senior Member
 
Bob86ZZ4's Avatar
 
Join Date: Feb 2009
Location: St. Paul, MN
Posts: 1,819
Default

You guys are too kind. I'm notoriously a hack when it comes to doing anything wood related. I'm much better with metal. I worked some more today and got the framing in for the cupboard and the water/propane monitor panel in.





Figuring out something for the under oven area and a door over that side cupboard is next. I'm trying to decide if I should box in that area underneath and put a door on it, or just block it off with a board. It would be a lot of work and there's not much room after I would finish it. But, you can never have too much cupboard space. I think that panel for the tanks turned out okay. I hope I can make a door look okay.
__________________
'03 Freightliner FL112, 295" wheel base, with '03 United Specialties 26' living quarters, single screw, Cat C12 430 h/p 1650 torque, Eaton 10speed , 3.42 rear axle ratio
Bob86ZZ4 is offline   Reply With Quote