Thread: Wall Slide
View Single Post
Old 02-25-2010, 03:48 PM   #3
Bob86ZZ4
Senior Member
 
Bob86ZZ4's Avatar
 
Join Date: Feb 2009
Location: St. Paul, MN
Posts: 1,819
Default

The top panel on mine is very flat. One time we were camping and the rig was level without my jacks down. It rained very hard all night. The slide has a auto canopy that rolls out over the top when you slide it out. I ran the slide in and then pulled out. Woooooshhhhh. A ton of water came flying off the top of the slide onto the kitchen. I guess that top might be a bit concave? I would have thought the canopy would have kept it dry. I guess it was blowing too much? I learned my lesson. If it's rained since putting the slide out I extend the jacks on the right side (the slide is on the left) so that any water that may be sitting up there will run off before the slide is brought in.
__________________
'03 Freightliner FL112, 295" wheel base, with '03 United Specialties 26' living quarters, single screw, Cat C12 430 h/p 1650 torque, Eaton 10speed , 3.42 rear axle ratio
Bob86ZZ4 is offline   Reply With Quote