View Single Post
Old 03-31-2010, 07:36 PM   #3
volvoman
Senior Member
 
Join Date: Aug 2009
Location: Rockford
Posts: 490
Default

max tube lenght is 60" from weld to weld. then you add on yoke lenghts. they make different lenght slip and stub lenghts. check with driveline shop for sizes. when measuring driveshaft lenght measure from center of u joint to center of u joint. if you go with a two piece driveline try to go with a 60/40 split. trans (front) should be short shaft. check crossmembers for where support bearing can be mounted.
volvoman is offline   Reply With Quote