Hello. I am in the process of building a conversion. I am needing some info on the proper way to secure the aluminum roof. I have steel square tube roof bows, with plywood screwed down to them. I dont know the proper method to stretch and glue(?) the aluminum continuous roof. Is there a type of glue that would glue it to the plywood? I will be using a 3" angle trim on the sides once the roof is in place. Thanks for any help.
|
Depending on the thickness of the aluminum you're using, and what all you're going to have on the roof (air-conditioners, tv antenna, roof vents, etc,... you may not need to worry about glue.
I used .030", have 2 roof airs' 3 vents, amp tv antenna, 4 solar panels, etc,...so it's pretty well fastened out in the middle. If you do want it fastened down,...counter-top contact cement should hold just fine. |
make sure the aluminum and the steel [screws or rivets]do not touch....they need a barrier between them....geofkaye
|
Thanks for the help. Is there a distributor of .030 102" wide continuous aluminum with no seams? All I have found is .040. Thanks again for your help
|
...what part of the country are you in....I have access but shipping is a heart attack....geofkaye
|
North Florida. I found the .040 at my local Great Dane semi trailer dealer/service center. I can by it reasonable and just pick it up. I guess I can give the thicker al. a try. Thanks for the help.
|
All times are GMT -5. The time now is 06:00 AM. |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.